Protocol display
Posted: Tue May 14, 2019 9:50 pm
What would cause the IQ Tester not show MA Net 2 or sACN protocols when connected to a network.
The network has three MA2 consoles and two OnPC stations and two NPUs running v3.7.0.1 running sACN output to 26 Pathway nodes receiving sACN final.
The IP range of all of the devices on the VLAN running this configuration is 192.168.103.xxx
The system is running and performing well, except for a software bug in 3.7.0.1 that effects web remotes.
All of the nodes are displaying active dmx and outputting data.
Plugging the tester into this network displays active devices, but no protocol indicators display as active, even though the network is active with. MA Net and sACN.
Plugging the tester directly into one of the MA2 desk activates the MA Net protocol indicator.
With the desk in sACN stand alone on, the sACN protocol indicator is red
Hooking the tester to my laptop running sACNVIEW software shows sACN protocol as active, and all tester functions appear to work fine.
Thanks
Henry
The network has three MA2 consoles and two OnPC stations and two NPUs running v3.7.0.1 running sACN output to 26 Pathway nodes receiving sACN final.
The IP range of all of the devices on the VLAN running this configuration is 192.168.103.xxx
The system is running and performing well, except for a software bug in 3.7.0.1 that effects web remotes.
All of the nodes are displaying active dmx and outputting data.
Plugging the tester into this network displays active devices, but no protocol indicators display as active, even though the network is active with. MA Net and sACN.
Plugging the tester directly into one of the MA2 desk activates the MA Net protocol indicator.
With the desk in sACN stand alone on, the sACN protocol indicator is red
Hooking the tester to my laptop running sACNVIEW software shows sACN protocol as active, and all tester functions appear to work fine.
Thanks
Henry