Page 1 of 1
Strange MAB length
Posted: Mon Sep 13, 2021 5:53 am
by Aki
I just find strange MAB length with ETC NET3 DMX node at ACN node.
I think this numbers are too long.
Or is this correct length?
See attached file
Re: Strange MAB length
Posted: Tue Sep 14, 2021 10:44 am
by Rihards
The reading is not correct.
Does it still show the same value after restarting the IQ Tester?
There is a problem with the Break/MAB measurements - the measurement will stop updating after it reads a very incorrect value like this.
A restart should fix the problem for now.
This usually happens when plugging in a DMX cable while DMX data is being sent on it.