You can find Release Notes, files and instructions HERE!
What's New in Version 1.5.0:
- Changelog:
- Multicast groups for MA-Net3 (and other supported protocols) are now joined automatically
- Added manual IGMP join/leave window for advanced users
- IGMP config is saved on the SD card (/Config/IGMP.tsv)
- Improved battery State of Charge % accuracy. Battery fuel gauge IC can now be updated from SD card
- AppleDouble / Dot Underscore ( ._ ) files are now hidden in Firmware Utility window
- Added TCNet and Pioneer Pro DJ Link to Protocol Detector*
- Still under development – currently only detected if transmitter subnet is eight bits long
- Added support for receiving multiple ArtTimeCode streams simultaneously
- Added the ability to specify PoE test mode (A, B, or both)
- In the DMX receiver DMX view with Value Display (48ch Bars/512ch Bars/512ch), orange bars now indicate the last received data when no new data is incoming
- Improved DMX Transmitter CMD keypad editor - made it less possible to enter invalid commands, added rotation and responses to physical buttons
- Bug Fixes:
- Fixed bug when IQ Tester would crash when switching Network Interface Configuration from DHCP to other modes
- Fixed DMX scope timing inaccuracy in 3 ms/div. mode
- Fixed a bug that caused RDM receiver to not register certain sensor values
- Fixed filesystem losing name sometimes
- Improved Art-Net Timecode Receiver and Transmitter UI
- Fixed invalid IP address not resetting correctly if config is corrupted
- Fixed a bug in DMX transmitter (16-bit RGB mode) where editing a channel value also affected unrelated channel values
- Fixed a bug preventing directed broadcasts to remote subnets when the destination IP was outside the IQ Tester’s local subnet