IQ Node - Viewing RDM Addresses

Ask us anything

Moderators: Logan, Oisín, Dmitry

Post Reply
Tepperse
Posts: 13
Joined: Wed Nov 18, 2020 12:44 pm

IQ Node - Viewing RDM Addresses

Post by Tepperse » Mon Mar 06, 2023 3:14 pm

Hey all,

Was viewing the RDM properties of fixtures on two separate outputs (and separate nodes) today when I realized the Address field was displaying incorrect values.

For one port, the RDM info was reporting that each fixture (7x CP Mini-Bs) were addressed to 22, when in reality they all have independent addresses.

For the other port, the RDM address info was changing sporadically for each of the fixtures (7x Chauvet Strike-Ms).These rolling changes happened between 1-10 seconds and was observed continuously over a 3-minute period. Fixtures were confirmed to have correct addressing in reality.

Nodes are receiving sACN from an MA.

Signal path is MA>EZLAN>GBS>IQ Node

Rihards
Posts: 49
Joined: Thu Mar 14, 2019 2:06 am

Re: IQ Node - Viewing RDM Addresses

Post by Rihards » Fri Mar 10, 2023 3:37 pm

What IQ node model and node firmware version are you using?
IQ Tester / IQ Two v2.x

Tepperse
Posts: 13
Joined: Wed Nov 18, 2020 12:44 pm

Re: IQ Node - Viewing RDM Addresses

Post by Tepperse » Wed Mar 22, 2023 12:11 am

One was a IQ 2 1616 2X running v2.22. The other was an IQ2 88 2X running 2.22.

Picture attached of matching address.

Video showing changing address can be found at: https://vimeo.com/810434777
Attachments
IMG_2393.jpg
Matching Addresses
IMG_2393.jpg (98.23 KiB) Viewed 77804 times

Tepperse
Posts: 13
Joined: Wed Nov 18, 2020 12:44 pm

Re: IQ Node - Viewing RDM Addresses

Post by Tepperse » Wed Mar 22, 2023 8:42 pm

Followup. I tried viewing the same fixtures with Node (IQ 88) set to Artnet only (though, no Artnet source in the network), and had the same issue of the address appearing to change sporadically.

Rihards
Posts: 49
Joined: Thu Mar 14, 2019 2:06 am

Re: IQ Node - Viewing RDM Addresses

Post by Rihards » Thu Mar 23, 2023 10:11 am

This is an IQ Two node firmware problem (v2.x versions before v2.26). This will be fixed in the next IQ Two node firmware release (v2.26).
Version v2.26 is being tested right now and is almost ready for release.
IQ Tester / IQ Two v2.x

Post Reply