Page 1 of 1

Sending sACN on a dedicated IP adress

Posted: Tue May 31, 2022 10:24 pm
by Rutger van Dijk
Hi There,

Im now on a project with a lot of sACN universes over a lot of IP addresses in the 10.150.17.xxx/24 range. If I want to use the IQ Tester LV (firmware 1.1.7r) to test some of the nodes I cannot get it to work. Appearantly this doesn't work, If I want to test universe 601-616 it gives automatic 239.255.2.89 to 239.255.2.104 as IP range. How does this work?

Also if I want to test the sACN signal coming from the controllers, the IQ Tester LV protocol detector doesn't show sACN and also the Packet Lister doesn't label the packages as sACN. Is this because of the custom IP 10.150.17.xxx/24 range? Does the protocol detector only/also react on dedicated IP addresses.

Of course my IQ Tester LV is in the right range, for this project on 10.150.17.252/24.

Keep up the great work!
Cheers,
Rutger

Re: Sending sACN on a dedicated IP adress

Posted: Wed Jun 01, 2022 1:39 pm
by Rihards
Hello

Right now in version 1.1.7, the IQ Tester can only send sACN to the automatic sACN multicast range 239.255.x.x
Also the sACN protocol detector in v1.1.7 only marks a packet as sACN if the destination is inside the 239.255.x.x range.

The next firmware release will have a modified sACN receiver that is able to detect sACN packets sent to any IP address (any IP address visible to the IQ Tester)

It was not planned for the sACN transmitter to be able to transmit to IPs outside the 239.255.x.x multicast range, but I will add this to the feature request list.

phpBB Appliance - Powered by TurnKey Linux