I just find strange MAB length with ETC NET3 DMX node at ACN node.
I think this numbers are too long.
Or is this correct length?
See attached file
Strange MAB length
Moderators: Daniel, Oisín, Logan, Dmitry
Strange MAB length
- Attachments
-
- 3A301145-1470-4CB6-9F64-4D0A2F3B1886.jpeg (64.46 KiB) Viewed 8703 times
Re: Strange MAB length
The reading is not correct.
Does it still show the same value after restarting the IQ Tester?
There is a problem with the Break/MAB measurements - the measurement will stop updating after it reads a very incorrect value like this.
A restart should fix the problem for now.
This usually happens when plugging in a DMX cable while DMX data is being sent on it.
Does it still show the same value after restarting the IQ Tester?
There is a problem with the Break/MAB measurements - the measurement will stop updating after it reads a very incorrect value like this.
A restart should fix the problem for now.
This usually happens when plugging in a DMX cable while DMX data is being sent on it.
IQ Tester / IQ Two v2.x