TMB Forum

Hello

This is not yet possible in v0.6.3.

The option to set the IQTester as an ethernet DMX gateway will be added in firmware v0.7.
Current latest version at the time of writing is v0.6.3.
Next firmware version release will be v0.7.

Thank you for reporting this

The IQTester will be able to notify the user about RDM and DMX timing errors in a later firmware version (v0.9 or v1.0)

Is it possible to set the reply time higher? The minimum Discovery -> Discovery Response time is defined as 176µs Ref: [ANSI E1.20 2010 RDM Spec. Table 3-2] The IQTester should be able to receive replies instantly after sending the Discovery packet, but there might be a hardware timing limitation or...

Does the Responder reply within 5.9ms of the discovery packet being sent out from the IQTester?

The discovery reply timeout is currently set to 5.9ms

The IQTester not being able to discover a single connected responder is something new. Does the responder reply to the discovery packets that are sent from the tester? If so, does the device count number in the IQTesters [RDM Device List] window go up to 1 or does it stay at "0"/"-" (Press the middl...

Hello Right now the only known problem with RDM is ACK_TIMER replies not being processed correctly. Was there only one or more than one RDM responder connected to the IQTester when trying to discover the dimmer? There was a problem with RDM discovery in version 0.5 related to RDM discovery branches ...

Hello Right now (version 0.6.3) it is not possible to set a value for all channels at once. A "thru" range option should be added in version 0.8 It is possible to keep transmitting DMX and exit edit mode: 1. Open the DMX-OUT window 2. Enter edit mode with the middle button and set channel values 3. ...

It seems like the IQTester is not receiving multicast packets from MANet2 and sACN when connected to the system through a network switch. MANet2 detection depends on the IQTester being able to receive packets from the MA2 multicast groups. Same for sACN if multicast addressing is used. This is happe...

It is possible to add a DMX start code counter -
This feature might be added closer to version 1.0

Version 0.7 is being developed at the time of writing this

After some deeper testing, I noticed that the OLA RDM dummy device's replies to RDM commands are a type of reply that is not yet supported by the IQ Tester (version 0.6.3 at the time of writing). Due to a bug in the IQ Tester firmware(<=v0.6.3), the lack of support for this type of reply is causing ...