TMB Forum

The ethernet port on the IQ Tester is 100Mbit

sACN is sent through multicast IP addresses. The subnet mask is not used for multicast.

The reading is not correct. Does it still show the same value after restarting the IQ Tester? There is a problem with the Break/MAB measurements - the measurement will stop updating after it reads a very incorrect value like this. A restart should fix the problem for now. This usually happens when p...

1. Can you please send the test result details of the 802.3af test? (after running the test, press [Details] in the 802.3af row) 2. Also do the A and B pair voltages show anything >0V during the test? 3. And if you have other switches available, does 802.3af or 802.3at finish successfully on any oth...

A fix for this problem will be added in the next firmware release.

Until then-
If this happens again, hold down [LEFT] and [RIGHT] buttons until the screen turns black or the startup screen appears again.
Holding down [LEFT] + [RIGHT] should restart the IQTester after 10-15 seconds.

A way to send custom UDP packets in string/hex/file format will probably be added at some point, but I don't know how soon that might happen

What exactly do you mean by Serial UDP commands? Don't think I have heard of anything like that before

Found another bug that would cause the IQTester to not be able to read or set parameters after a bad request label response. A fix will be included in the next firmware bugfix release.

We have found the issue that was causing the devices to constantly go offline. A bugfix version should be released this or next week.

This could be happening because the QTran LED driver might not support some RDM PIDs required to create a device profile/cache file. Any discovered RDM devices are marked as offline if they do not properly reply to PIDs required to create the cache file - that might be why the devices keep getting o...